Rs485 (-106) - Metrologic VoyagerGS MS9590 Installation And User Manual

S I
CANNER NSTALLATION

RS485 (-106)

1. Turn off the host device.
2. Plug the 10-pin RJ45 end of the
MVC cable into the 10-pin socket
on the MS9590. There will be an
audible click when the connector
lock engages.
3. Connect the other end* of the MVC
cable to the host device.
4. Turn on the host device.
5. The blue LED on the scanner will
turn on, the white LED will flash, and
the scanner will beep once.
6. Scan the bar code below to activate
the RS485 interface.
³ 9 9 9
USB is the default communication protocol for an MS9590-106.
If the recall defaults bar code is scanned after the unit has been
configured for RS485, the scanner will revert to the USB default
communication protocol. The bar code above will need to be rescanned
to return the unit to the RS485 communication protocol.
The scanner is shipped from the factory configured to set of default
conditions. Plugging the scanner into a port on the host system does
not guarantee that the scanned information will be communicated
properly to the host device. The scanner and host device must use the
same communication protocol. Please refer to the MetroSelect Single-
Line Configuration Guide or the help files provided with MetroSet2 for
instructions on changing the scanner's factory default configuration.
See caution on page 6.
* The type of host connection available on an MVC cable is application
dependent. Contact a customer service representative at 1-800-ID-METRO for
additional information on the MVC converter cable series.
8
9 9 5
Figure 6.