JVC XV-C3SL Service Manual page 8

Hide thumbs Also See for XV-C3SL:

Table of Contents

XV-C3SL

2.1.3 Removing the mechanism assembly

(see Fig.4,5)

• Prior to performing the following procedure, remove the top

cover, front panel assembly and bracket.

(1) Remove the three screws D attaching the mechanism as-

sembly.

(2) The servo control board is removed from the connector

CN961 and CN701 connected with the main board re-

spectively.

2.1.4 Removing the servo control board

(see Fig.6)

• Prior to performing the following procedure, remove the top

cover, front panel assembly, bracket and mechanism assem-

bly.

(1) Disconnect the card wire from connector CN201 and

CN202 on the servo control board respectively.

(2) Disconnect the flexible wire from connector CN101 on the

servo control board from pick-up

ATTENTION:

At this time, please extract the wire after short-cir-

cuited of two places on the wire in part c with solder.

Please remove the solder two places of part c after

connecting the wire with CN101 when reassem-

bling.

(3) Two places in hook d are removed, the servo control

board is lifted, and it is removed.

Fig.4

Fig.5

Fig.6

Table of Contents

Chapters

Table of Contents