JVC XV-C3SL Service Manual page 11

3.1.3 Removing the traverse mechanism assembly
(See Fig.4 and 5)
• Prior to performing the following procedure, remove the
clamper assembly and the tray.
(1) Remove the four screws B attaching the traverse mechanism
assembly.
ATTENTION:
Before reattaching the traverse mechanism assembly,
pass the card wire extending from the spindle motor
board through the notch d of the elevator.
3.1.4 Removing the elevator
(See Fig.6)
• Prior to performing the following procedure, remove the
clamper assembly, the tray and the traverse mechanism as-
sembly.
(1) Extend each bar e inside of the loading base
outward and detach the elevator shaft.
ATTENTION:
When reattaching, first fit the two shafts on the
front of the elevator to the slots f of the slide cam.
Fig.6
XV-C3SL
Fig.4
Fig.5
11