Rear Panel Connections - Marantz SR-14EX User Manual

REAR PANEL CONNECTIONS

All connections to the rear panel should be made with the entire
system powered off.
To avoid errors, it is advisable to connect one cable at a time between
the various components.
11
21 10 16
FRONT SURROUND
L R L
COAX COAX
OUT OUT
L R L
FRONT SURROUND
S - VIDEO
OPT OPT
OUT OUT
DIG .1 DIG .1
IN
TV LD DVD
S2 IN S2 IN S2 IN
DIG .2 DIG .2
IN
DIG .3 DIG .3
IN
DIG .4 DIG .4
IN IN
L
DIG .5 DIG .5
IN IN
R
DIG .6 DIG .6
/
TV LD DVD
RF IN RF IN
19 20 9 5
8
1 FM antenna terminal (75 ohms)
Connect an external FM antenna with a coaxial cable, or a cable
network FM source.
2 AM antenna and ground terminals
Connect the supplied AM loop antenna. Use the terminals marked
"AM" and "GND". The supplied AM loop antenna will provide good
AM reception in most areas. Position the loop antenna until you hear
the best
3 Three analog audio inputs
CD, TAPE, and CD-R/MD :
Connect the audio outputs of your source components to the input
jacks on the receiver.
4 Two analog audio outputs for audio
source equipment
TAPE and CD-R/MD :
Connect each output to the audio inputs (REC in) of your recording
equipment.
5 Five analog audio inputs for video
source equipment
TV,LD,DVD, VCR1, and DSS/VCR2 :
Connect each input to the audio outputs of your video source
equipment.
6 Two analog audio outputs for video
source equipment
VCR1, and DSS/VCR2 :
Connect each output to the audio inputs (REC in) of your video
recording equipment.
17 18 14
(FRONT)
R L R
MAIN
IN
PRE
OUT
R L R
SUB
SURROUND BACK
CENTER
WOOFER
VCR1
IN
MONITOR
OUT
VCR1 VCR1 DSS / VCR2 DSS / VCR2 DSS / VCR2 DSS / VCR2 MONI.
S2 IN OUT S2 IN S2 OUT
OUT
MULTI
VIDEO MONI.
ROOM
IN – VCR1 – OUT IN – DSS/VCR2 IN DSS/VCR2 – OUT OUT AUDIO AUDIO CD
AUDIO MULTI
ROOM
6 12 3
15
1 2 13 22
FM (75 FM (75 ) GND GND AM AM
ANTENNA
COMPONENT VIDEO
Y Cr
Y Cr
DVD DVD
IN IN
DSS DSS
/ VCR2 / VCR2
IN
DIRECT IN
SUB
CENTER SURROUND
WOOFER
L R
IN
OUT
IN – TAPE – OUT IN – CD-R / MD IN CD-R / MD – OUT OUT REMOTE MULTI
AUDIO REMOTE CONTROL
4 23 24
7 6-Channel Inputs
If an external digital audio decoder is used, connect the outputs of
that decoder to these jacks. Note that front L&R channels are
common used in analog audio inputs, use the assigned input in OSD
setup menu system.
(See page 18 "System setup 1/2".)
8 Five video inputs
TV,LD,DVD, VCR1, and DSS/VCR2 :
Connect each input to the video outputs of your video source
equipment.
9 Two video outputs
VCR1, and DSS/VCR2 :
Connect each output to the video input (REC in) of your video
recording equipment.
10 Five S-video inputs
TV,LD,DVD, VCR1,and DSS/VCR2 :
Connect each input to the S-video outputs of your video source
equipment.
11 Two S-video outputs
VCR1, and DSS/VCR2 :
Connect each output terminals to S-video input (REC in) of your video
recording equipment.
12 Monitor. (VIDEO/S-VIDEO) output jacks
Connect this jack to the composite or S-Video input of a TV monitor or
video projector to view the on-screen menus and the output of any
standard video source selected by the receiver's video switcher.
10
R L
FRONT FRONT
R SURROUND SURROUND L
S P E A K E R S P E A K E R S Y S T E M S S Y S T E M S 8 8 O H M S O H M S
AC OUTLETS
120V 60HZ
SWITCHED 120W 1A SWITCHED 120W 1A
UNSWITCHED 120W 1A UNSWITCHED 120W 1A
7 25
CENTER
AC INLET AC INLET
26