Installation Precautions And Requirements; Quick Connect Instruction - Pentair S2000-SEA User Manual

Energon reverse osmosis water purification system
Table of Contents

Advertisement

4.2. Installation Precautions and Requirements

• The product is provided with a booster pump. This product can be installed on the municipal tap
water supply inlet pipe.
• Accessible 110-220V power socket.
• Install the product in a clean and hygienic location, with no surrounding pollution, away from direct
sunlight, flammable and explosive materials or electrical equipment, and sheltered from rain.
• The electrical circuit must be installed by certified professional.
• Turn off the main power supply and modify the circuit carefully according to the user' s requirement.
Such work must comply with relevant electrical installation procedures and regulations.
• Upon completion of the modification, conduct a circuit check and clean up the area.

4.3. Quick Connect Instruction

The water outlets connections of the product are equipped with quick connector ports. The quick
connector port allows for quick and firm connections without the use of any tools.
• Connecting and disconnecting the PE tube to the quick connector port
When connecting, pull out the horseshoe shaped clip. Cut squarely across one end of the supplied PE
tube and insert the cut end fully into the connector port. Ensure that the PE tube is inserted through
the seal ring of the connector. Then, tug the PE tube slightly outward to generate a small gap between
the moveable plastic ring and the port opening. Reinsert the horseshoe shaped clip onto the gap to
complete the connection.
Blue horseshoe shaped
clip
Plastic ring
Opening
To remove the PE tube from the water outlet quick connector: First, pull out the horseshoe shaped clip.
Next, push the moveable plastic ring located at the connector port inward such that it is flush with the
port opening. Lastly, simply pull out the PE tube.
Do not pull out the PE tube by force.
Properly connected
port
Remove the
Push in the tube
horseshoe shaped
firmly
clip
Remove the horseshoe
shaped clip
Tug slightly outward
to create a little gap
Push the plastic ring
inwards
Reinsert the
horseshoe shaped
clip
Press the plastic ring
down and pull out the tube
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

S10-sea

Table of Contents