Related Manuals for Pentair S2000-SEA
Summary of Contents for Pentair S2000-SEA
- Page 1 ENERGON REVERSE OSMOSIS WATER PURIFICATION SYSTEM USER’S MANUAL MODEL: S2000-SEA, S10-SEA...
-
Page 2: Table Of Contents
CONTENTS _____________________________________________________________________________________________________________ 1. PRECAUTIONS AND GENERAL NOTES ....................3 2. PARTS INCLUDED ..........................4 3. PRODUCT INFORMATION ........................5 3.1 Product Structure ........................5 3.2 Product Features ........................5 3.3 Specifications ..........................6 3.4 Schematic Diagrams ........................6 3.5 Introduction to Main Parts ......................7 4. INSTALLATION AND COMMISSIONING .....................8 4.1 Tools and Materials ........................8 4.2 Installation Precautions and Requirements ................9 4.3 Quick Connect Instruction ......................9... -
Page 3: Precautions And General Notes
CAUTION Please read this instruction manual carefully before installing and using this product. If you encounter any problems that are not addressed in this manual, please contact your local Pentair’ s distributor. WARNING: • To prevent damage to the system or property, •... -
Page 4: Parts Included
• If an error or leak occurs, unplug the power • Please replace the filter cartridge regularly plug and turn off the tap water supply with a genuine Pentair filter cartridge, inlet valve immediately. Do not operate a according to the filter cartridge replacement malfunctioning product. -
Page 5: Product Information
(Model S2000-SEA only). • RO (Pure) water can used for drinking and cooking. • Filtered (Clean) water can be used for food preparation and washing (Model S2000-SEA only). • Integrated quick change filter cartridge for easy filter replacement. -
Page 6: Specifications
Faucet Check valve Inlet water solenoid valve Filter Filter Filter cartridge 3 cartridge 2 cartridge 1 Filtered Booster pump (Clean) water (S2000-SEA only) Water Purifier Faucet (S2000-SEA model only) Reject water to Drain Drain solenoid valve RO (Pure) water... -
Page 7: Introduction To Main Parts
Φ74mm, L312mm 3 pieces 5 years Water tank Polypropylene 1 unit 5 years Dual faucet Stainless steel 1 piece 5 years (Model S2000-SEA) Single faucet Copper 1 piece 5 years (Model S10-SEA) PE plastic tubes Polyethylene 5 years Integrated waterway Polypropylene... -
Page 8: Installation And Commissioning
• The installation instructions below serve only as a guide. The installation, commissioning and maintenance of this product must be carried out by qualified technicians designated by an authorized Pentair’ s distributor. Installation by unauthorized person may damage the product and damage so caused will not be covered by warranty. -
Page 9: Installation Precautions And Requirements
4.2. Installation Precautions and Requirements • The product is provided with a booster pump. This product can be installed on the municipal tap water supply inlet pipe. • Accessible 110-220V power socket. • Install the product in a clean and hygienic location, with no surrounding pollution, away from direct sunlight, flammable and explosive materials or electrical equipment, and sheltered from rain. -
Page 10: Installation Steps
• Installing the water purification system’s faucet: At the position where the faucet is to be installed, make a mark on the stainless steel sink with a hammer and center punch (to facilitate drilling). Drill a Φ 29mm (model: S2000-SEA) or Φ 12 mm (model: S10-SEA) hole with an electric drill and install the faucet. - Page 11 *Dual faucet is applicable for S2000-SEA only Filtered water water Filtered (Clean) water connector (model S2000-SEA only) RO (Pure) water connector 1/4” Tube 1/4” Tube Note: • If the power supply is cut off after water production, the machine will stop producing water.
-
Page 12: Operating Instructions
5. OPERATING INSTRUCTIONS _____________________________________________________________________________________________________________ NOTE: The reverse osmosis membrane is treated with a sanitizing agent to prevent microbial contamination, which should be flushed from the system. While using the system for the first time or replacing the reverse osmosis membrane (second-stage filter), it is recommended to perform rinsing for 60 minutes and soaking the RO membrane for 24 hours before using it normally. -
Page 13: Normal Operation
NOTE: Initially, the water may appear cloudy. This is a result of air trapped in the post-polishing filter. It is not harmful and will disappear in a matter of minutes. It may take up to a week after installing a new post-polishing filter for the trapped air to dissipate. -
Page 14: Water Purification System Monitoring
The replacement cycle for a filter cartridge depends on the water supply quality and volume of filtered (Clean) (for model S2000-SEA only) and RO (Pure) water usage by the user. Regular cartridge replacement ensures the normal operation of the water purification system and the quality of clean (model S2000-SEA) and pure water produced. -
Page 15: Steps For Replacement Of Filter Cartridge
6.2. Steps for Replacement of Filter Cartridge Replace the filter cartridge according to the machine’ s lifespan reminder or the recommended replacement cycle. Please contact your local Pentair authorized distributor for replacement of filter cartridges. 1. Turn off power to the water purification system and shut the inlet 3-way ball valve. Open the faucet and discharge it until no more water flows out of the faucet. -
Page 16: Troubleshooting
7. TROUBLESHOOTING _____________________________________________________________________________________________________________ Problem Possible Cause(s) Solution The system does not PE tube is bent Remove bend from PE tube produce water or Check if the three-way ball valve Open the three-way ball valve Reduced outlet water is closed flowrate Check if the tap water is flowing Wait for the tap water supply to resume... -
Page 17: Terms And Conditions Of Warranty
Installation, maintenance and repair services will be provided by Pentair’ s authorized distributors. In the event that the user is unable to present the warranty card or valid purchase invoice, Pentair will deem the warranty to have expired and charge the relevant fees. - Page 18 371 He Shan Road | New District Suzhou | Jiangsu 215011 | China | pentair.com All Pentair trademarks and logos are owned by Pentair. All other brands or product names are trademarks or registered marks of their respective owners. Because we are continuously improving our products and services, Pentair reserves the right to change specifications without prior notice.