Removing The Appliance From The Rack - IBM 7199-92X Installation And User Manual

Figure 19. Removing the SFP+ transceiver

Removing the appliance from the rack

Best Practice: Two people should slide the appliance forward on the rails for
Generally, after installing the appliance in the rack, you need to remove it only
under the following conditions:
v To move it to another position in the rack
v To return it as a defective appliance to IBM
Note: Do not return a appliance to IBM unless explicitly instructed by a support
Removing the appliance from the rack
CAUTION:
Type 7199: The weight of this part or unit is between 18 and 32 kg (39.7 and 70.5
lb.). It takes two persons to safely lift this part or unit. (C009)
To remove the appliance from the rack, complete the following steps:
Note: Make sure two people lift the appliance, with hands positioned as illustrated
1. Unlatch and rotate the front of the appliance, as shown in Figure 20 on page 52.
A
removal. One person should pull from the front, and the other
should push from rear.
representative.
> 18 kg (39.7 lb)
by 2 in Figure 20 on page 52.
a. If the appliance is not turned off, press the power button located on the
front of the chassis. The power LED should not be illuminated.
b. Unplug all power cords.
Chapter 7. Removing or replacing the appliance or parts
51