Viewing Status Providers For Sensors - IBM 7199-92X Installation And User Manual

Figure 13. LEDs on the rear on the Type 7199 appliance
The rear of the appliance has the following LEDs:
A, B and C
D and E

Viewing status providers for sensors

The DataPower appliance provides the following sensors status providers:
Fan speed sensors
Temperature sensors
Voltage sensors
RAID battery backup status
B
A
The fan module LEDs indicate the following status:
v If the amber LED is lit, there is a problem with the fan module.
v If the amber LED is not lit, the fans are operating normally.
The power supply module LEDs indicate the following status:
v If the amber power LED is lit, the power supply has an error.
v If the LED is not lit, the power supply is working as expected.
Provides the measured speed in revolutions per minute (RPM) for each of
the fans in each fan module.
From the command line, enter status fan.
Provides the measured temperature for internal components:
v Temperature of each of the two internal CPU components
v Temperature of each of the two internal inlet air temperatures
v Temperature of each of the two outlet air temperatures
v System ambient temperature
From the user interface, click Appliance → Troubleshooting → Hardware
Temperatures.
From the command line, enter status temperature.
Provides the measured voltage for the internal components.
From the command line, enter status voltage.
Monitors the battery backup unit on the RAID controller.
From the command line, enter status raidphystatus.
C D
Chapter 5. Diagnosing your appliance
E
29