Tool Requirements; Installation Overview - IBM 7199-92X Installation And User Manual

CAUTION:
Removing components from the upper positions in the rack cabinet improves
rack stability during relocation. Follow these general guidelines whenever you
relocate a populated rack cabinet within a room or building:
v Reduce the weight of the rack cabinet by removing equipment starting at the
v If the rack cabinet you are relocating is part of a suite of rack cabinets, detach
v Inspect the route that you plan to take to eliminate potential hazards.
v Verify that the route that you choose can support the weight of the loaded
v Verify that all door openings are at least 760 x 230 mm (30 x 80 in.).
v Ensure that all devices, shelves, drawers, doors, and cables are secure.
v Ensure that the four leveling pads are raised to their highest position.
v Ensure that there are no stabilizer brackets installed on the rack cabinet
v Do not use a ramp inclined at more than 10 degrees.
v When the rack cabinet is in the new location, complete the following steps:
v If a long-distance relocation is required, restore the rack cabinet to the
(R002)

Tool requirements

You will need the following tools, hardware, and cables to install the appliance
rack-mounting kit:
v A medium Phillips screwdriver
v Two (2) standard rack screws
You will need the following cables to connect the appliance to your network:
v At least two (2) network cables, but up to twelve (12) for the Type 7199

Installation overview

The overall installation process makes the following assumptions:
v You have fully unpacked the appliance and have located the included two (2)
v You need to install the mounting rails and have the rack-mounting kit.
12
WebSphere DataPower XC10 Appliance: Type 7199-92X: Installation and User's Guide
top of the rack cabinet. When possible, restore the rack cabinet to the
configuration of the rack cabinet as you received it. If this configuration is not
known, you must observe the following precautions:
– Remove all devices in the 32U position and above.
– Ensure that the heaviest devices are installed in the bottom of the rack
cabinet.
– Ensure that there are no empty U-levels between devices installed in the
rack cabinet below the 32U level.
the rack cabinet from the suite.
rack cabinet. Refer to the documentation that comes with your rack cabinet for
the weight of a loaded rack cabinet.
during movement.
– Lower the four leveling pads.
– Install stabilizer brackets on the rack cabinet.
– If you removed any devices from the rack cabinet, repopulate the rack
cabinet from the lowest position to the highest position.
configuration of the rack cabinet as you received it. Pack the rack cabinet in
the original packaging material, or equivalent. Also lower the leveling pads to
raise the casters off of the pallet and bolt the rack cabinet to the pallet.
appliance.
power cords, one (1) USB-A to DB9-M serial adapter cable, and one (1) RJ45 to
DB9-F serial console cable.