Connecting The Device To A Transducer - Garmin ECHOMAP UHD2 5X Installation Instructions Manual

Connecting the Device to a Transducer

Go to garmin.com/transducers
transducer for your needs.
NOTE: If you use an existing transducer and the transducer cable pin connector does not match the device port,
an 8-pin to 4-pin transducer cable adapter (Garmin part number 010-12719-00) is included with some device
bundles and available at garmin.com.
1 Follow the instructions provided with your transducer to correctly install it on your boat.
2 Route the transducer cable to the back of your device, away from sources of electrical interference.
3 Align the divot on the transducer cable connector with the keying on the XDCR port on the back of the device.
You must align the holes on the cable connector with the pins in the cable port. Misalignment of the cable
connection could damage the devices.
4 Push the connector firmly into the port until fully seated.
If the device behaves erratically, the cable connector may not be fully seated. Disconnect the cable connector
from the port, check the pin alignment, and firmly push the connector into the port.
Connecting Devices Wirelessly to Share User Data and Sonar
You can connect two ECHOMAP UHD2 devices wirelessly to share user data and sonar.
See your Owner's Manual for more information.
8
or contact your local Garmin dealer to determine the appropriate type of
NOTICE