Power Cable; Connecting The Device To Power - Garmin ECHOMAP UHD2 5X Installation Instructions Manual

Power Cable

When connecting the power cable, do not remove the in-line fuse holder. To prevent the possibility of injury or
product damage caused by fire or overheating, the appropriate fuse must be in place as indicated in the product
specifications. In addition, connecting the power cable without the appropriate fuse in place voids the product
warranty.
• The power cable (included) connects the device to power.
• If it is necessary to extend the power and ground wires, you must use 0.82 mm
NOTE: Disregard the blue and brown wires.
Item Wire Function
Power
Ground
Not used
Not used

Connecting the Device to Power

When connecting the power cable, do not remove the in-line fuse holder. To prevent the possibility of injury or
product damage caused by fire or overheating, the appropriate fuse must be in place as indicated in the product
specifications. In addition, connecting the power cable without the appropriate fuse in place voids the product
warranty.
NOTE: Disregard the blue and brown wires on the wiring harness.
1 Route the power cable between the power source and the device.
2 Connect the red wire from the wiring harness to the positive (+) battery terminal.
3 Connect the black wire from the wiring harness to your boat's common ground or to the negative (-) battery
terminal if no common ground is available.
4 Align the divot on the power cable connector with the keying on the POWER port on the back of the device.
You must align the holes on the cable connector with the pins in the cable port. Misalignment of the cable
connection could damage the device.
5 Push the connector firmly into the port until fully seated.
If the device behaves erratically, the cable connector may not be fully seated. Disconnect the cable connector
from the port, check the pin alignment, and firmly push the connector into the port.
WARNING
Wire Color
Red
Black
Blue
Brown
WARNING
NOTICE
2
(18 AWG) or larger wire.
7