Table of Contents

Advertisement

When storing the unit at the end of the mowing season, the
mower and battery should have the following items serviced
before storage.
If the mower has been stored for an extended period of
time, follow the new season preparation steps before
beginning operation.
General mower preparation for storage
1. Remove all grass, dirt, and trash from mower and
cutting units.
IMPORTANT: Wash the machine with a mild detergent
and water. Do not pressure wash the machine. Avoid
excessive use of water, especially near the control
panel and controllers.
2. Clean mower and deck and touch up all scrapes with
touch-up paint.
3. Check thoroughly for any worn or damaged parts that
need replacing and order them from your dealer.
4. Block mower up so weight is off tires. Check tire
pressure and inflate to proper operating pressure.
5. Do not deflate tires.
6. Store mower in a clean, dry place.
127675

STORAGE

Preparation of battery for storage
When storing the machine for long periods, it is
recommended to leave the battery connected to the charger.
New season preparation
Before starting the mower following post season storage,
the following service is required:
1. Clean mower, removing trash and dirt accumulation.
2. Tighten any bolts that have loosened and make sure all
hair pins, cotter pins and clevis pins are in place.
3. Install all safety shields and review safety precautions
listed in this manual.
4. Check and inflate tires to 8-12psi (55–83 KPa)
6-1
REV B

Advertisement

Table of Contents
loading

Table of Contents