Bissell SYMPHONY PET 1132 Series Instructions Manual page 8

Maintenance & Care
Cleaning or Replacing the
Vacuum Filter
The key to maximum performance is having
clean filters. Cleaning the filters after each use
will help your vacuum operate at peak efficiency.
Use only genuine BISSELL® Symphony™ Pet
replacement filters in your machine. To purchase
visit BISSELL.com.
To clean filter:
1. Turn power OFF and unplug steam mop.
2. Follow the steps on page 7 to remove the
dirt tank.
3. Remove the filters and tap them firmly against
the inside of a waster basket, removing any
visible dirt.
4. Replace filter into the dirt tank and attach
tank back on the vacuum base. Be sure to move
the lock lever back to the right to lock.
NOTE:
• After heavy usage, you may clean the pre-
motor, foam filter by washing it gently by hand
in warm water and mild dish detergent. Rinse
thoroughly and make certain it is completely dry
before replacing it.
• It is recommended to replace the paper,
pleated filter every 6 months.
Thermal Protector
An internal thermal protector has been
designed into your vacuum to protect it
from overheating. When the thermal protector
activates, the vacuum motor will stop
operating. If this happens:
1. Turn the cleaner OFF and unplug from
electrical outlet.
2. Empty dirt tank, check filters and
air passages for dirt accumulation.
3. The thermal protector automatically resets
after approximately 2 hours. If the thermal
protector does not reset, call BISSELL Consumer
Care or visit support.BISSELL.com.
8 BISSELL.com
WARNING
To reduce the risk of electric shock,
turn power OFF and disconnect
polarized plug from electrical outlet
before performing maintenance or
troubleshooting checks.
3.