680 EXPORT SERIES
14.2
Pump Does Not Operate but Light Does
Press the JETS 1 Button:
1. If no water movement is detected, make sure power is going to
the spa and check the water level. If it does not solve the problem,
contact your authorized Sundance dealer.
2. The main pump operates but no water flows to jets. Pump may not
be properly primed. This can happen after the spa is drained and
refilled.
A. Press the JETS 1 button several times, never leaving the motor
on for more than 5 to 10 seconds at a time. Turn power off and
let the air out removing the filter cartridge. Refer to Section 11.1
(page 34). Make certain you reinstall the filter cartridge before
turning on spa power and restarting the jets pump.
14.3
Poor Jet Action
1. Press the JETS 1 button to make certain the pump #1 is on.
2. Open all air control to the "on" position.
3. Check for dirty filter. Clean, if necessary.
4. Make sure jets are all the way open.
14.4
Water is Too Hot
Reduce thermostat setting.
14.5
No Heat
1. Check thermostat setting.
2. Keep the spa cover in place while heating.
3. Check the settings to see if your spa is in economy filtration/heating
mode (page 31).
Should checking the above steps fail to correct the problem, please call
your dealer so that they may arrange service.
We build the best spas in the industry. Nonetheless, we are always
striving to improve the quality and features of our products. Your input as
a Sundance spa owner is a cherished part of this process. If you have
any comments or suggestions, or if you wish to be informed on any new
products for your spa, please write to us.
CONGRATULATIONS on your good taste and welcome to the happiest
and most relaxed family in the world!
Page 46