Sundance Spas Denali 680 Series Owner's Manual page 28

680 EXPORT SERIES
CAUTION: TO DECREASE BUILD UP ON COMPONENTS AND
MINIMIZE ACRYLIC DAMAGE.
Never fill with water from a water softener. If your water is extremely
"hard", it is preferable to fill half-way with hard water and the rest of
the way with softened water. Water that is too soft can be corrosive
to metal components.
13. Consult your authorized Sundance dealer for chemical recommenda-
tions, then add chemicals to spa water to achieve a constant sani-
tizer reading within the levels recommended on the inside cover of
this manual.
14. Turn on jets pump(s) when adding chemicals to ensure proper mixing
and leave your spa cover open until the sanitizer level becomes
stable to protect pillows and plastic knobs from chemical attack.
Refer to the inside cover of the manual.
WARNING:
!
• To decrease the risk of injury, entrapment or drowning,
never leave your hot tub unattended for any reason,
especially if while the cover is open and accessible to
small children and animals!
• To decrease the risk of contracting a waterborne illness
(e.g. an infection, bacteria or virus) and/or respiratory
ailments, maintain water chemistry within 6 step
parameters. If you or other bathers experience such a
condition, discontinue use and seek immediate medical
attention.
15. Establish a sanitizer reading no less than 1.0 ppm free chlorine
or 2.0 ppm bromine, then allow the hot tub to set undisturbed for
8 hours. Retest water after 8 hours to determine if sanitizer levels
are stable. If sanitizer levels are stable, your spa is ready for use.
To ensure healthy water conditions, always maintain a constant
sanitizer reading within the levels recommended on the inside cover
of this manual. If sanitizer levels are not stable at this time, it will be
necessary to repeat this procedure in its entirety (steps 1-15) until
stable sanitizer readings are achieved.
IMPORTANT: If the CLEARRAY® water purification system is removed
from the hot tub or is not operating effectively follow the "without
CLEARRAY®" water chemistry parameters as defined by the Association
of Pool and Spa Professionals.
16. After adequate sanitizer levels are achieved, close all spa air controls
to maximize heat retention when spa is not in use.
Page 22
RISK OF PERSONAL INJURY.