Advertisement
Special Tools
Order special tools from your Toro Distributor. Some
tools may also be available from a local supplier.
Multimeter
The multimeter can test electrical components and cir-
cuits for current, resistance or voltage.
NOTE: Toro recommends the use of a DIGITAL Volt--
Ohm--Amp multimeter when testing electrical circuits.
The high impedance (internal resistance) of a digital me-
ter in the voltage mode will make sure that excess cur-
rent is not allowed through the meter. This excess
current can cause damage to circuits not designed to
carry it.
NOTE: Workman MDE vehicles use a 48 volt, DC elec-
trical system. If multimeter is not of the auto--range type,
make sure to properly set multimeter range before per-
forming any voltage test.
Battery Terminal Protector
Battery Terminal Protector is an aerosol spray that
should be used on all battery and controller terminals to
reduce corrosion problems. Apply terminal protector af-
ter cable has been secured to terminal.
Toro Part Number: 107- -0392
Dielectric Gel
Dielectric gel should be used to prevent corrosion of
connection terminals. To ensure complete coating of ter-
minals, liberally apply gel to both component and wire
harness connector, plug connector to component, un-
plug connector, reapply gel to both surfaces and recon-
nect harness connector to component. Connectors
should be thoroughly packed with gel for effective re-
sults.
Toro Part Number: 107- -0342
Workman MDE
Page 3 - - 5
Figure 3
Figure 4
Figure 5
Electrical System
Advertisement
Chapters
Troubleshooting
