Toro Workman MDE 2008 Service Manual page 107

Removal (Fig. 13)
1
1. Park vehicle on a level surface, turn on/off switch
OFF, set parking brake and remove key from the on/off
switch.
2. Open the battery circuit by carefully removing one of
2
the battery cables (see Opening Battery Circuit in the
A
General Information section of Chapter 3 -- Electrical
System).
3. Remove hood using Figure 13 as a guide.
Installation (Fig. 13)
4
NOTE: Do not tighten fasteners securing the hood until
Figure 14
all fasteners are in place.
1. Negative cable to vehicle 2. Positive cable to vehicle
1. Install hood using Figure 13 as a guide. During as-
sembly, use fastener torque specifications that are iden-
tified in Figure 13.
2. Reconnect removed battery cable to battery termi-
nals. Install lock washer and nut on battery terminals.
Torque nuts from 115 to 125 in- -lb (13.0 to 14.1 N- -m).
Workman MDE Page 5 - - 21 Chassis