Charger Interlock Switch - Toro Workman MDE 2008 Service Manual

Charger Interlock Switch

The charger interlock switch is located behind the char-
ger receptacle plate on the front of the seat base (Fig.
28). When the battery charger is plugged into the char-
ger receptacle, the interlock switch closes and provides
an input to the vehicle controller to inhibit vehicle opera-
tion.
NOTE: The vehicle should not operate if the charger
plug is connected to the charger receptacle.
1. Make sure vehicle on/off switch is OFF. Remove key
from switch.
2. Remove receptacle plate from front of seat base.
3. Locate charger interlock switch on rear of receptacle
plate. Disconnect harness connector from the switch.
4. Check the continuity of the switch by connecting a
multimeter (ohms setting) across the connector termi-
nals.
5. When the switch plunger is extended there should
not be continuity between the switch terminals.
6. When the switch plunger is depressed, there should
be continuity between the switch terminals.
7. Replace switch if needed.
8. Reconnect harness connector to switch. Install re-
ceptacle plate to front of seat base.
Workman MDE
1
4
3
2
1. Receptacle plate
2. Screw (4 used)
2
1. Charger interlock switch
2. Switch plate
3. Charger receptacle
4. Rivet (2 used)
Page 3 - - 19
Figure 28
3. Charger receptacle
4. Charger interlock switch
1
7
3
5
6
Figure 29
5. Lock nut (2 used)
6. Socket head screw
7. Mount bracket
Electrical System
4