Table of Contents
Advertisement
4. Select the type of calibration mode.
To perform stacking correction, select "Stacking", then
select "Master Projector" or "Auto" for the calibration
mode.
* When performing stacking correction by specifying the
master projector, select the number of the projector to
be the master.
To perform tiling correction, select "Tiling", then select
"Specify Four Points" or "Auto" for the calibration mode.
5. Click [Next]
The calibration screen will be displayed.
6. Click [Setup] and adjust the camera.
* When photographing with [Options]
capture mode] checked, the web camera's continuous
image is displayed.
Adjust the position of the camera to fit within the
photographing range of the projector's projected image,
then click [Auto-Tune] to set the image's quality to the
optimal values for calibration.
After making the settings, click [Finish] to return to the
calibration screen.
7. Click [Calibrate]
Calibration will start.
Four types of test image (illustrated below) will be projected onto the screen in order.
Note
• During the calibration, please pay attention to the following points:
- Do not touch the installation platform of the camera or projector.
- Do not cut across in front of the camera.
- Do not let shadows from outside light fall upon the screen.
• Press the ESC key on the keyboard to cancel calibration.
5. Performing Stacking/Tiling Correction
→
[Continuous
23
Advertisement
Table of Contents
