Multi Screen Tool Menu - NEC NP-PA600 Series User Manual

Multi Screen Tool Menu

File
Options
Help
Open the GCXS file (extension .gcxs) saved with the [Save as] command
and send the geometric correction data to all connected projectors.
When using a GCXS file to reproduce projected images to which
stacking/tiling correction has been applied, make sure the installation and
connections of all the projectors are the same as when the GCXS file was
saved.
Open
Projected images to which stacking/tiling correction has been applied
cannot be reproduced if the order in which the projectors are connected,
their position of installation, the projection angle (including tilt feet
adjustment), position of projection (including lens shift adjustment), etc.,
have been changed.
Save as
The geometric correction data of all the connected projectors along with
* This becomes
the order in which the projectors are connected is stored together as the
selectable once
stacking/tiling correction data (GCXS file).
stacking/tiling
c o r r e c t i o n i s
* For tiling correction, the edge blending data (JPG file) is also stored.
completed.
Exit Closes the Multi Screen Tool.
At this screen, select the projectors to be used for stacking/tiling
correction.
Select the type of network (type of NIC: network interface card) with the topmost
pull-down menu.
Connect
Update
Communication
Settings
Input Address
Edit List
Mode Changes the projectors' geometric correction and edge blending settings.
Help
This displays the help file of the Multi Screen Tool.
About
Displays the version of the Multi Screen Tool.
Connects to the projectors for which check marks are
entered.
Updates the list display when there has been an increase or
decrease of the number of network projectors, when there
has been a change in the type of projector, or some other
change.
Specifies and searches the IP address of the projector.
The search method can be selected from the following two
types.
• Direct input and searching of the projector IP address
• Specification and searching of a range with start address
and end address
Specifies an address and registers on a list the projectors
that have been searched. This also permits post registration
editing and deletion, and additions and searches by address
specification.
18
3. Multi Screen Tool Settings