Preparing The Remote Control - JVC DX-T5 Instructions Manual

@
Front main speakers and matrix surround
speakers
• When connecting the speaker cords, match their polarity
with that of the speaker terminals: red/white to (+) and black
to (–).
1
3
From right front main
speaker
From right matrix
surround speaker
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the System.
• The front main speakers are magnetically shielded to avoid
color distortions on TVs. However, if not installed properly,
it may cause color distortions. So, pay attention to the
following when installing the speakers.
– When placing the speakers near a TV set, turn off the
TV's main power switch or unplug it before installing the
speakers.
Then wait at least 30 minutes before turning on the TV's
main power switch again.
Some TVs may still be affected even though you have
followed the above instruction. If this happens, move the
speakers away from the TV.
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom
of the speakers.
2
4
From left front
main speaker
From left matrix
surround speaker
To remove the speaker grilles of the main speakers
Holes
¤
Powered subwoofer
From the powered subwoofer
(not supplied)
#
To adjust the voltage selector
Use a screwdriver to rotate the
voltage selector so that the voltage
mark is pointing at the same voltage
as where you are plugging in the unit.
(See also the back cover page.)
Voltage mark
DO NOT plug in before setting the voltage
selector and all connection procedures are
complete.

Preparing the remote control

R6(SUM-3)/AA(15F)
• Dispose of batteries in the proper manner, according to
federal, state, and local regulations.
DO NOT recharge, short, disassemble or
heat the battery or dispose of it in a fire.
Projection
Speaker grille
When using the remote
control, point the top of the
remote control toward the
remote sensor as directly as
possible. If you operate it
from a diagonal position,
the operating range (approx.
5 m) may be shorter.
5