Mounting - Smeg SI2951D Original Instructions Manual

Flush built-in model
For this kind of hobs additional milling is
needed in the recessed hole if you wish to
install the hob flush with the work surface.
L H
900 514
A B
min. min.
50 460
60
Installation
G X
839 ÷ 482 ÷
904
844 486
C D
min. min.
20÷60
750
After laying the adhesive seal (A) on the
glass surface and after positioning and
securing the hob, fill the edges with
insulating silicone (B) and wipe away any
excess.
In the event the hob needs to be removed,
cut the silicone using a cutter before
attempting to remove it (C).

5.6 Mounting

Over built-in oven unit
If installed on top of an oven, the
latter must be equipped with a
cooling fan.
The clearance between the hob and the
kitchen units or other built-in appliances
must be enough to ensure sufficient
ventilation and air discharge. If installed
above an oven, a space must be left
between the bottom of the hob and the top
of the appliance installed below.
Y
E
50
opens on bottom