Care and cleaning
Sunbeam Cleaning Tablets
Keeping your coffee machine clean ensures
great tasting coffee. Sunbeam Cleaning
Tablets remove oil build up and prolongs the
life of your coffee machine.
• Preparing for cleaning cycle
- Ensure the water tank is full and the drip tray
is empty.
- Remove the cleaning disc from the
accessories storage home (underneath the
water tank lid).
- Ensure the machine is on and in the READY
state.
1 L
1 L
- Place the 2 CUP filter basket and the
MIN
MIN
cleaning disc into the group handle.
- Place one Sunbeam Cleaning Tablet in the
middle of the cleaning disc in the space
provided.
- Insert group handle into the group head.
- Place a large container under the group head
and steam wand.
• Start the cleaning cycle
- The cleaning cycle takes approximately 7
ON / OFF
ON / OFF
minutes to complete.
- Ensure the machine is plugged in and
switched on at the power outlet.
26
MAX
MAX
2.8 L
2.8 L
PRESS & HOLD TOGETHER 4 SEC
PRESS & HOLD TOGETHER 4 SEC
MANUAL SHOT
MANUAL SHOT
Note: Do not press the STANDY button.
- Press and hold down the 1 CUP and 2 CUP
buttons.
- While holding down the 1 CUP and 2 CUP
buttons, press the STANDBY button.
- Once the lights on the control panel start to
chase from left to right, release the 1 CUP
and 2 CUP buttons.
- The lights on the control panel will
continue to chase until the cleaning cycle is
completed.
Note: During the cleaning cycle, all other
functions will be locked until the cleaning
cycle is completed. The cleaning cycle can
be stopped at any point by pressing the
STANDBY button.
• Cleaning cycle complete
- When the cleaning cycle is completed, the
lights on the control panel will stop chasing
and the machine will beep 4 times.
- The machine will now be in the READY state.
- Remove the group handle from the group
head. Check tablet has fully dissolved.
Note: If the tablet has not been dissolved,
repeat the cleaning cycle.
• Cleaning cycle clean up
- Empty the containers from under the group
handle and steam wand.
- Rinse the parts in warm soapy water.
- Purge the group head by pressing the 1 CUP
button.
- Allow water to run through until it stops.
- Wash the parts in warm soapy water.
- Rinse and dry.
- The machine is now ready for use.
26