Using Remote Controller; Overview; Using The Remote Controller To Control Each Device; Controlling The Dtr-9.1 - Integra DTR-9.1 Instruction Manual

Using remote controller

SEND/LEARN
indicator
POWER ON
AUDIO/TAPE
MODE
POWER ON
SLEEP
AUDIO/TAPE
MODE
DISPLAY
CH
Re-EQ
LATE NIGHT
DIMMER
56
POWER
STNBY
POWER STNBY
LIGHT
VOL
TEST
AUDIO MUTING
MUTING
TRACK DISC
REC OPEN/COLSE
OPEN/CLOSE
INPUT
DVD CD
SELECTOR
T1 T2 TUN PH
buttons
V1 V2 V3 V –
Listening
STEREO DIRECT DSP
1 2 3
mode buttons
SURROUND THX DSP
4 5 6
LEVEL +
Re-EQ CH SEL
LEVEL +
7 8 9
LEVEL –
LATE NIGHT DIMMER
LEVEL –
+ 10 0
ENT
CH SEL
HOME THEATER CONTROLLER
RC-418M

Overview

The RC-418M remote controller is a useful tool to help
you operate the components of your home theater. To
do so, first press the MODE button that corresponds to
the device you wish to control. At this time, the display
on the remote controller will change to show the com-
ponent that is selected. Then simply press the desired
operation button and the component will operate ac-
cordingly. For example, if you wish to select the CD in-
put source at the DTR-9.1 with the remote controller,
first press the AUDIO/TAPE MODE button to select the
DTR-9.1 ("AUDIO" will appear on the display) and then
press the CD (INPUT SELECTOR) button.
Using the remote controller to control each
device
In order to use the remote controller, you must first turn
on the POWER switch at the DTR-9.1 so that it enters
standby mode.
1. Press the AUDIO/TAPE MODE button.
"AUDIO" appears in the remote controller display.
2. Press the POWER ON button to turn on the DTR-
9.1 and press the POWER STNBY button to put it
back in the standby mode.
When you press the POWER STNBY button on the re-
mote controller, it puts the DTR-9.1 in the standby
state but does not turn it completely off.
SEND/LEARN indicator
This indicator acts as a guide when commands are pro-
grammed into or sent by the remote controller. It also
warns the user when an error is made or battery power
is low.

Controlling the DTR-9.1

If "AUDIO" is already appears in the display, proceed
to step 2.
1. Press the AUDIO/TAPE MODE button.
"AUDIO" appears in the remote controller display.
2. Press the desired operation button. The
buttons shaded in the figure to the left are the
operation buttons that can used to control the
DTR-9.1.