Navigating Through The Osd Menu - Integra DTR-9.1 Instruction Manual

The On-Screen Display (OSD) menu
OSD
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.Zone2 OSD Setup
6.About
Select: Exit:|EXIT|
Enter:|ENTER| Quit:|OSD|
Main menu
Display

Navigating through the OSD menu

The explanations here assume you are using the
buttons on the DTR-9.1 when entering the OSD menu.
However, you can use the buttons on the remote
controller as well.
The buttons on the remote controller correspond to
those on the DTR-9.1 as shown below.
Button on remote controller
OSD MENU
(upper edge of
ENTER button)
(lower edge of
ENTER button)
(left edge of
ENTER button)
(right edge of
ENTER button)
ENTER
EXIT RETURN
1.Speaker Setup
1.Speaker Config
2.Speaker Distance
3.Level Calibration
4.Bass Peak Level
5.LFE Level Setup
Menu
Button on DTR-9.1
(under door)
MENU
UP
DOWN
LEFT
RIGHT
ENTER
EXIT
1-1.Speaker Config
a.Subwoofer
b.Front
c.Center
d.Surround L/R
Quit:|OSD|
e.Surround Back
1. Press the MENU button.
The main menu screen of the OSD menu appears
on your TV monitor.
2. Using the and
menu that you want to enter.
3. Press the ENTER button to enter the selected
menu.
The screen for that menu appears.
4. Using the and
sub-menu that you want to enter, and press
the ENTER button.
Each sub-menu has different settings that can be
changed as desired, and they are all explained be-
low. To change a setting, first select it using the
and cursor buttons, and then change the setting
using the and cursor buttons.
5. Press the EXIT button to set the new settings
and return to the previous menu screen, and
again to return to the main screen.
Note:
Press the MENU button to exit the OSD menu immedi-
ately.
:Yes
:Large
:Large
:Large
:Large
Quit:|OSD|
Sub menu
cursor buttons, select the
cursor buttons, select the
29