Connecting The Power - Integra DTR-9.1 Instruction Manual

Connecting the power

Standby/On
Standby indicator
Standby/On
Standby
Zone 2 ( GRN )
( )
Rec RED
Display DVD
Power
On Off
Power
Connecting the power
• The DTR-9.1 is shipped with the main power (POWER)
switch in the on position (
cord is plugged in for the first time, the DTR-9.1 will
automatically enter the standby state and the
STANDBY indicator will light (same condition after
step 2 below).
• Before you plug in the DTR-9.1, confirm that all con-
nections have been made properly.
• Turning on the power may cause a momentary
power surge, which might interfere with other elec-
trical equipment on the same circuit, such as com-
puters. If this happens, use a wall outlet on a differ-
ent circuit.
1. Plug the power cord into an AC wall outlet.
2. Press the POWER switch to set the DTR-9.1 to
standby state.
The STANDBY indicator will light up.
3. Press the STANDBY/ON button to turn on the
DTR-9.1. The display will light up and the
STANDBY indicator will turn off.
Display
If you press the STANDBY/ON button again, the re-
ceiver returns to Standby mode.
Video 1 Video 2 Video 3 Video 4 Video 5 Tape 1 Tape 2 AM
). When the power
ON
INPUT ANALO G
VIDEO
COMPONENT
DVD 1
SEND/LEARN
indicator
POWER ON
AUDIO MODE
Master Volume
FM Phono C D Open/Close
DTR-9.1
Turning the power on from the remote controller:
Before you can use the remote controller, you must
perform steps 1 and 2 above and place the DTR-9.1 in
the standby state.
1. Press the AUDIO MODE button.
2. Press the POWER ON button to turn on the DTR-
9.1 (take it out of the standby state).
• To return the DTR-9.1 to the standby state, press
the POWER STNBY button.
POWER
STNBY
AUDIO MUTING
TRACK DISC
REC OPEN/COLSE
DVD CD
T1 T2 TUN PH
V1 V2 V3 V –
STEREO DIRECT DSP
1 2 3
SURROUND THX DSP
4 5 6
Re-EQ CH SEL LEVEL +
7 8 9
LATE NIGHT DIMMER LEVEL –
+ 10 0 ENT
HOME THEATER CONTROLLER
RC-418M
27