Icom IC-756 Instruction Manual page 10

1
PANEL DESCRIPTION
i756
NB NR
BAL NR
COMP KEY SPEED BK-IN DELAY
$7 MEMORY UP/DOWN SWITCHES [Y Y ]/[Z Z ] (p. 41)
• Select the memory channel number for the se-
lected readout.
- Memory channels can be selected both in VFO and
memory modes.
• Select the desired memory channel directly after
pushing [F-INP] and a memory channel number.
$8 MEMORY WRITE SWITCH [MW] (p. 43)
Stores the selected readout frequency and operat-
ing mode into the displayed memory channel when
pushed for 2 sec.
- This function is available both in VFO and memory
modes.
$9 MEMORY CLEAR SWITCH [M-CL] (p. 45)
Clears the selected readout memory channel con-
tents when pushed for 2 sec. in memory mode.
- The channel becomes a blank channel.
- This switch does not function in VFO mode.
7
14.195.000
14.205.000 14.205.000
F-1 F-2 F-3 F-4
SSB CW RTTY AM
1.8 1 3.5 2 7 3
SPLIT
10 4 14 5 18 6
DUAL
WATCH
21 7 24.5 8 28 9
CHANGE
F-INP
GENE ・ 50 0
ENT
VFO/
MEMO
MP-W MP-R
MAIN/
SUB
RX
TX
F-5
SPEECH
FM
%0 QUICK TUNING SWITCH [TS] (p. 24)
• Turns the quick tuning step ON and OFF.
- While the quick tuning indicator is displayed, the fre-
quency can be changed in programmed kHz steps.
- 1, 5, 9 and 10 kHz quick tuning steps are available.
14.100.00
• While the quick tuning step is OFF, turns the 1 Hz
step ON and OFF when pushed for 2 sec.
- 1 Hz indications appear in both readouts and the fre-
quency can be changed in 1 Hz steps.
• While the quick tuning step is ON, enters the quick
tuning step set mode when pushed for 2 sec.
%1 TRANSMIT FREQUENCY CHECK SWITCH
[XFC]
Monitors the transmit frequency when pushed and
held when the split frequency function is ON.
- While pushing this switch, the transmit frequency can be
changed with the tuning dial, keypad, memo pad or the
[Y]/[Z] switches.
- When the split lock function is turned ON, pushing [XFC]
cancels the dial lock function. (p. 57)
$ 7 $ 8 $ 9 % 0 % 1
TWIN PBT
▲
▼
MW
APF AUTO NOTCH
M-CL
APF CW PITCH
TS
XFC
LOCK
RIT TX CLEAR
RIT/ TX
LOCK
Quick tuning indicator