Hunter 44905 Owner's Manual page 42

Features
Advanced Menu Options
5. SPAN 2 : Unless you have a multi-stage conventional or heat pump system, there
is no need to change the second stage span. If you do, use the
adjust between 1, 2, or, 3. Press
to make no changes. Second stage span acts the same as your primary, but it
determines when and how long your second stage heat runs.
6. Auto Season Span: When your thermostat is set to "Auto", this setting allows the
thermostat to switch between heat and cool modes based off the room temperature.
The auto season span limits how close your heat and cool set temperatures can be
to allow the thermostat to switch between the two modes properly. Use the
buttons to adjust between 3
Example: If you set your heat temperature for a schedule to be 68
would be able to set your cool temperature for that schedule would be 73
auto season span of 5. Assuming you have a stage 1 span of 2, see page 40 for stage
1 span description, a heating temperature of 68
your thermostat will activate heat at 67
continues to rise up to 74
switch to cooling, run to 72
heating if the temperature drops to 67
7. Temperature Calibration: If your thermostat seems to be running a degree or two
hot or cold, you can set the calibration here. Use the
between -2 to 2
O
42
Next
to 6 . Press
O O
and run till 69
O
, 1 above your cooling temperature, your thermostat will
O O
and then shut down. The thermostat will switch back to
O
, 1
O
. Press to advance to the next option.
O
Next
44040-01 • 03/24/2010
6
once this has been changed or if you need
to advance to the next option.
Next
, and a cooling temperature of 73
O
and shut off. If the temperature
O
below your heat temperature.
O
or buttons to
or
, the lowest you
O
, with an
O
or buttons to adjust
,
O