Engine Oil Pressure Sensor - Remove And Install - Perkins 1106C Series Disassembly And Assembly

168
Disassembly and Assembly Section
Illustration 339
1. Lubricate a new O-ring seal (4) with clean engine
oil. Install the new O-ring seal onto coolant
temperature sensor (3).
2. Use a deep socket in order to install coolant
temperature sensor (3) to the cylinder head.
Tighten the coolant temperature sensor to a
torque of 15 N·m (11 lb ft).
3. Connect harness assembly (2) to coolant
temperature sensor (3).
4. Slide locking tab (1) into the locked position.
5. Fill the cooling system to the correct level. Refer
to Operation and Maintenance Manual, "Cooling
System Coolant Level - Check" and refer to
Operation and Maintenance Manual, "Cooling
System Coolant - Test/Add" for the correct filling
procedure.
Engine Oil Pressure Sensor -
Remove and Install
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting, and repair of the product. Be prepared
to collect the fluid with suitable containers before
opening any compartment or disassembling any com-
ponent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
g01341684
Illustration 340
1. Slide locking tab (1) into the unlocked position.
2. Disconnect harness assembly (2) from engine oil
pressure sensor (3).
3. Use a deep socket to remove engine oil pressure
sensor (3) from the cylinder block.
4. Remove O-ring seal (4) from engine oil pressure
sensor (3).
i02654485
Installation Procedure
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
KENR6932
NOTICE
g01341698
NOTICE