Crankcase Breather - Install (Unfiltered Breather) - Perkins 1106C Series Disassembly And Assembly

106
Disassembly and Assembly Section
Illustration 203
2. Remove canister (20) for the breather. Refer to
Operation and maintenance Manual, "Crankcase
Breather (Canister) - Replace".
3. Loosen clamp (19) and remove hose (21).
4. Release two spring clamps (14) in order to remove
hose (15). Remove the hose.
5. Remove bolts (17). Remove base (18) from the
inlet manifold.
If a spacer is installed between the base and the
inlet manifold, remove spacer (16).
6. Carefully pry cover (1) from breather body (4).
Note: Note the orientation of the outlet.
7. Remove gauze (2) from breather body (4).
8. Remove O-ring seal (3) from breather body (4).
9. Use Tooling (A) in order to unscrew breather body
(4) from adapter plate (8).
10. Remove O-ring seal (5) from breather body (4).
11. Remove bolts (6) and washers (7) from adapter
plate (8).
12. Remove adapter plate (8) from valve mechanism
cover (10).
13. Remove O-ring seal (9) from adapter plate (8).
Crankcase Breather - Install
(Unfiltered Breather)
Installation Procedure
Table 48
Tool
A
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
g01339655
component life.
Illustration 204
Breather tool
Required Tools
Part
Part Description
Number
-
Breather Tool
NOTICE
KENR6932
i02654407
Qty
1
g01339595