Removing Protective Materials; Installing The Td Cartridge - Sharp AR-121E Service Manual

3. UNPACKING
Unpack the copier and carry it to the installation location by
holding the handles on both sides of the copier.
4. REMOVING PROTECTIVE
MATERIALS
(1) Remove pieces of tape (a), (b), (c), (d), (e), (f), (g) and (h)
and protective cover (i). Then open the original cover and
remove protective materials (j) and (k).
c
a
f
b
(2) Use a coin (or suitable object) to remove the screw.
Store the screw in the paper tray because it will be used if
the copier has to be moved.

5. INSTALLING THE TD CARTRIDGE

(1) Open the side cover while pressing the side cover open
button.
PACKING
g h
e
d
(2) Remove the CAUTION tape from the front cover and
remove the two protective pins from the fusing unit by pull-
ing the strings upward one at a time.
CAUTION tape
(3) Push gently on both sides of the front cover to open the
cover.
(4) Remove the TD cartridge from the bag. Remove the
protective paper. Hold the cartridge on both sides and
shake it horizontally four or five times.
(5) Hold the tab of the protective cover and pull the tab to your
side to remove the cover.
(6) Gently insert the TD cartridge until it locks in place, while
pushing the lock button.
5-2
AL-1000/1010
Protective pins
Lock button