Table of Contents
Advertisement
Installation procedure
Wiring technique:
Installation instructions
To use the remote control unit, install a 5-wire terminal block and adhere an infrarred emitter close
to the switch receiver. Connect anode and cathode to A, B on the terminal board; connect +5V, GND,
RUN coming from the switch independently from C, D, E of the 5-wire terminal block.
MS-SVN056C-EN
Wired
Remote Control
Terminal board
This board accepts 5-wire cable which length
should match actual conditions.
Remote control
back cover
Remote control
front cover
LCD screen
Control panel
Control panel
cover
To join the front cover to
the back side of the remote
control, latch the first lug
and then latch the other.
To separate both parts pry borders
using the tip of a screwdriver
Wooden
screw (M4X20)
Terminal block protrudes from the
back cover; a perforation is required
to allow for correct mounting.
It must not be connected directly
to the wall!
Mounting screws B
SET TEMPERATURE(°C)
ST2.9x10-C-H
AUTO
FAN
COOL
HIGH
DRY
MED
HEAT
LOW
TEMP
FAN
ON/OFF
MODE
SPEED
ECONOMIC
SWING
TIMER
RUNNING
VENT
CANCEL
LOCK
RESET
Remote control
Wired Controller
47
Advertisement
Table of Contents
