Table of Contents
Advertisement
General Information
General
These instructions are offered as guidelines for the proper installation, start-up and operation for
universal coupling systems 2MX/2MW. However, these do not contain all fully required procedures
for a continued operation free of obstacles. Therefore, it is important to contract a professional
service agency for such matters. Read these instructions carefully before installing the equipment.
Warranty
Warranty is based upon general terms and conditions of the manufacturer. Warranty may be
nullified if the equipment were to be modified or repaired without the express approval of the
manufacturer, or if operation limitations were to be exceeded, or if electrical wiring of the system
were to be altered. Any damage to the equipment as a result of bad use of same, or lack of
maintenance, or non-compliance with instructions offered by the manufacturer, will not be covered
by the warranty. Warranty will be automatically cancelled if the user does not adhere to the rules
described in this manual.
Reception
Upon arrival, inspect the unit before signing approval of delivery. Specify any damages observed
at the time of delivery and report same in writing to the transportation company, within 72 hours
of delivery. At the same time, notify your local sales representative of these damages. Inspect the
unit within the first 7 days of delivery. If any concealed damage is detected, advise of same in
writing to the transportation company within 7 days of delivery, as well as to your local sales
representative.
About the Unit
Before shipping, the unit covered in this manual are assembled, dehydrated, charged and leak
tested. This document contains information related to the units of Universal Coupling.
Refrigerant
Refrigerant provided by the manufacturer complies with all Trane unit requirements. When using
recycled or reprocessed refrigerant, it is recommended to ensure that the quality is equivalent to
new refrigerant. To do this, it will be necessary to order an analysis of said refrigerant by a
specialized laboratory. Any action contrary to this measure, will compel the manufacturer to anull
the warranty.
IMPORTANT:
The unit must be installed in accordance with national regulations for electrical installations.
These instructions do not cover all variations in the system, nor do they foresee all possible
contingency. If further information were to be required or if problems should arise which are not
covered sufficiently in this manual, the matter should be turned over to the local Trane Sales Office.
6
MS-SVN056C-EN
Advertisement
Table of Contents
