Disassembly - Kohler 17RES Manual

6.2 Disassembly

The disassembly procedure
information to minimize disassembly time and indicates
where special configurations exist which may require
taking notes.
Remove enclosure
Remove the generator set enclosure as described in the
following steps. See Figure 6-1.
1. Open the enclosure roof.
2. Place the generator set master switch in the OFF
position.
3. Remove the screws on one end of the roof stay to
disconnect the roof stay. See Figure 6-2.
4. Remove one roof hinge: Use two screwdrivers to
compress the hinge springs. See Figure 6-2.
5. Remove the roof.
Compress
hinge springs
Remove
two screws
1. Hinges
2. Roof
3. Door stay (GM51973)
4. Bracket
Figure 6-2 Roof Stay and Hinges
74 Section 6 Disassembly/Reassembly
provides important
1
2
4 3
6
1
2
1. Roof
2. Right side door
3. Front panel
4. Heat shield (inside, not shown)
5. Left side panel
6. Rear panel
Figure 6-1 Enclosure Parts, Order of Disassembly
3
5
4
3
ADV7341
GM51561D-E
TP-6519 8/17