Bosch SMV6HCX02A User Manual page 50

aus Troubleshooting
Fault
Appliance does not
start.
Programme starts
automatically.
Appliance stops dur-
ing the programme or
cuts out.
All LEDs lit up or
flashing.
Fault
Appliance door can-
not be closed.
50
Cause and troubleshooting
Check whether the socket works.
1.
Check whether the mains cable is properly inserted
2.
in the socket and on the rear of the appliance.
Appliance door is not closed properly.
Close the appliance door.
▶
You did not wait until programme ended.
→ "Terminate programme", Page 31
▶
Appliance door is not closed properly.
Close the appliance door.
▶
Power and/or water supply has been interrupted.
Check the power supply.
1.
Check the water supply.
2.
Top basket is pressing against inner door and pre-
venting appliance door from being closed securely.
Check whether the rear panel of the appliance is
▶
being pressed in by a socket or hose holder that
has not been removed.
Arrange the tableware so that no parts project bey-
▶
ond the basket and prevent the appliance door
from closing properly.
Electronics have detected a fault.
Press the main switch button for approx.
1.
4 seconds.
→ "Controls", Page 15
The appliance is reset and restarted.
If the problem occurs again:
2.
Switch off the appliance.
‒
Pull out the mains plug or switch off the fuse in
‒
the fuse box.
Wait at least 2 minutes.
‒
Switch on the fuse in the fuse box or insert the
‒
mains plug.
Switch the appliance on.
‒
If the problem occurs again:
3.
Contact customer service.
‒
→ "Customer Service", Page 54
Cause and troubleshooting
Door lock has been activated.
Close the appliance door with greater force.
▶
Door cannot be closed due to installation method.