Fault
Connection to home
network is not estab-
lished.
WLAN display is flash-
ing.
Home Connect cannot
be implemented cor-
rectly.
Fault
Refill indicator for
rinse aid lights up.
Refill indicator for
rinse aid does not
light up.
Fault
Water is left in the ap-
pliance at the end of
the programme.
Appliance cannot be
switched on or oper-
ated.
Appliance does not
start.
Cause and troubleshooting
WLAN on router is not active.
Check the wireless network connection of your
▶
router.
Connection to home network is not available.
Activate the wireless network connection on your
▶
router.
Home Connect set incorrectly.
Please consult the documents supplied for
▶
Home Connect.
Technical fault is present.
Please consult the information about support in the
▶
documents supplied for Home Connect.
Cause and troubleshooting
Insufficient rinse aid.
Add Rinse aid → Page 24.
1.
Set the amount of rinse aid to be dispensed.
2.
→ "Setting the amount of rinse aid", Page 25
Rinse aid system is switched off.
Set the amount of rinse aid to be dispensed.
▶
Cause and troubleshooting
Filter system or area under the filters is blocked.
Clean the Filters → Page 38.
1.
Clean the Wastewater pump → Page 52.
2.
Programme has not yet ended.
Wait until the programme ends or cancel the pro-
▶
gramme with Reset.
→ "Terminate programme", Page 31
▶
Software update is taking place.
Wait until the software update has finished.
▶
Appliance functions have failed.
Pull out the mains plug or switch off the fuse.
1.
Wait at least 2 minutes.
2.
Connect the appliance to the power supply.
3.
Switch the appliance on.
4.
The mains fuse has tripped.
Check the relevant fuse.
▶
Mains cable is not inserted.
Troubleshooting aus
49