User Maintenance Instructions - Central Pneumatic CONTRACTOR 92359 Set Up And Operating Instructions Manual

drive cylinder of the tool. Make sure
to dry off the Roofing Nailer before
use. Any oil film left after cleanup will
accelerate tar buildup.
7. When finished using the Roofing
Nailer, always disconnect the tool
from its compressed air supply.
Attempt to fire the Roofing Nailer
into a piece of scrap wood to ensure
it is disconnected and is incapable
of firing any nails. Empty the Nail
Canister (82) completely of nails
8. Make sure to store Roofing Nailer in
its Carrying Case and in a clean, dry,
safe location out of reach of children.
9. If the tool requires more force to
accomplish the task, verify that the
tool receives sufficient, unobstructed
airflow (CFM) and increase the
pressure (PSI) output of the regulator
up to the maximum air pressure
rating of this tool.
CAUTION! TO PREVENT TOOL
AND ACCESSORY FAILURE,
RESULTING IN INJURY:
Do not exceed the tool's maximum
air pressure rating.
10. Clean external surfaces with clean,
dry cloth. Then store the tool indoors
out of children's reach.
USER-MAINTENANCE
INSTRUCTIONS
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
SKU 92359 For technical questions, please call 1-800-444-3353.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION, BEFORE ANY
MAINTENANCE OR REPAIRS
ARE DONE (including clearing
jams):
• Wear ANSI-approved safety
goggles with side shields.
Other people in the work area
must also wear ANSI-approved
impact safety goggles with side
shields.
• Release the trigger.
• Detach the air supply.
• Attempt to fire the Tool into a
piece of scrap wood to ensure
that it is incapable of firing
any fasteners.
• Empty Canister and leave it
open during service.
TO PREVENT SERIOUS
INJURY FROM TOOL
FAILURE: Do not use
damaged equipment. If
abnormal noise, vibration,
or air leaks is detected, have
the problem corrected before
further use.
TO PREVENT EXPLOSION:
Lubricate only with specified
lubricants. Lubricate air inlet
using only pneumatic tool oil.
Lubricate internal mechanism
using only white lithium
grease. Other lubricants may
damage the mechanism and
may be highly flammable,
causing an explosion.
Page 13