Remote Controller Battery Installation; Charging The Vehicle - Mattel Hot Wheels Cybertruck User Manual

3: SET UP
A. REMOTE CONTROLLER BATTERY INSTALLATION
1. Slide open the battery cover.
2. Install 4 AA (LR6) alkaline batteries (not included) with
polarity (+/-) as shown inside the battery compartment.
For longer life, use alkaline batteries.
3. Slide the battery cover back on the remote controller.
4. Replace batteries in the remote controller if the vehicle
does not respond well after a recharge or if you see a
red light flashing in the LED indicator during play.
B. CHARGING THE VEHICLE
The vehicle is powered by a Lithium-ion (Li-ion) battery pack,
and it must be fully charged with the included wall charger before first use.
1. Plug the wall charger into a standard wall outlet.
2. Connect the battery pack's charger connector to one end of the adapter. Connect the other
end of the adapter to the wall charger to begin charging. Make sure the connectors are
tightly attached.
3. A red LED will light up on the wall charger to indicate the battery pack is charging. Green
LEDs will also light up on the adapter to indicate the battery charge level. Charging is
complete when the wall charger LED turns green or when the green LEDs on the adapter
reach 100%. A full charge will take approximately 60 minutes. Charging time may vary.
6
4. To disconnect the wires, push down on the
connector clip and pull apart.
5. Unlike alkaline batteries, where the power
loss is gradual, a Li-ion battery will run for
its normal running time (approximately 10 to
30 minutes depending on driving style and
mode) and then lose most of its power at
once. It is now time to recharge the battery.
TIPS:
• Charging the battery for more than what is recommended will not give you a longer
running time.
• The battery will be hot after play. Wait at least 10 to 15 minutes until the battery cools
down before recharging the battery.
• When red LEDs light up on the adapter, you should unplug the
charger connectors from both ends of the adapter. Wait at
least 10 minutes until the battery and adapter resume normal
operation before charging the battery again.
Battery Charge Level Indicator
7