Speed Modes; Consumer Information - Mattel Hot Wheels Cybertruck User Manual

SPEED MODES

The Cybertruck is equipped with two speed modes:
CHILL MODE and SPORT MODE.
Chill Mode is the default speed mode your vehicle is in once it is
switched on. Sport Mode, on the other hand, increases the vehicle's
throttle power and allows for a higher speed.
To switch to Sport Mode, press and hold the Speed Mode button
for approximately 5 seconds. The remote controller's LED will flash
quickly to indicate the vehicle is in Sport Mode. To switch back
to Chill Mode, press and hold the Speed Mode button again
for approximately 5 seconds or switch the remote controller and
vehicle OFF then back ON so it returns to the default speed mode.
NOTES:
• Speed modes cannot be switched when the vehicle is in motion. Stop the vehicle and wait
until it is still before switching modes.
• The vehicle will consume more battery power when it is in Sport Mode.
12

5: CONSUMER INFORMATION

TIPS & HINTS – FOR ALL DRIVING ENVIRONMENTS
1. When your vehicle starts to lose power, it may lose functions or performance. It's time for a recharge. For best
performance, always start with a fully-charged battery. Your vehicle's running time may change depending on driving
style and driving environment.
2. Radio interference can make your vehicle run badly. Interference can be caused by other RC vehicles running on the
same frequency, electrical wires, large buildings, CB radios, or other wireless gear. Try to stay away from these!
3. Point your remote controller up, and not down toward your vehicle. If your vehicle gets too far away, it won't work
properly.
4. Don't store your vehicle near heat or in direct sunlight. Always turn switches OFF and remove all batteries from the
remote controller before storage.
5. Don't drive your vehicle in sand or through water or snow. Do not immerse in water. If your vehicle does get wet,
wipe it with a towel and allow to dry completely overnight. If your remote controller is accidentally dropped in water,
remove battery(ies) and allow your remote controller to air-dry. Replace with fresh battery(ies) before operation.
6. When exposed to an electrostatic source, the remote controller and/or the vehicle may malfunction. To resume
normal operation of the remote controller, remove the batteries and reinstall them after 5 seconds. To resume normal
operation of the vehicle, turn the power OFF for 5 seconds, then turn it ON again.
7. For extended storage, make sure to charge the battery before storing so that the battery does not become depleted
over time. The battery should be charged once a year if the vehicle is to remain in storage.
13