Advertisement
II.BATTERY INSTALLATION
Note: Your vehicle can be used with a Tyco® R/C 9.6V NiMH
battery pack or 6 AA alkaline batteries.
Requires a Tyco® R/C 9.6V NiMH battery pack or 6 AA
alkaline batteries for vehicle and 2 AA alkaline batteries for
transmitter.
Though your vehicle can run on both 9.6V or 6 x AA
batteries, it will run up to 30% faster when using a
9.6V rechargeable battery.
Vehicle
9.6V NiMH battery pack
1. Rotate the battery latches, as shown, to unlock the battery
cover. Swing the battery cover up and away from the vehicle.
2. Use a screwdriver (not included) to unscrew and remove
the AA battery adapter. Store in a safe place for later usage.
3. Insert the 9.6V NiMH battery pack (not included), with
polarity (+/-) as shown inside the battery compartment .
4. Plug the wire connector into the battery compartment as
shown.
5. Replace the battery cover.
6. Turn "ON" the Power Switch.
6 AA alkaline batteries
1. Rotate the battery latches, as shown, to unlock the battery
cover. Swing the battery cover up and away from the vehicle.
2. Make sure the AA battery adapter is firmly in place. If it's
not, position the adapter in the box and fasten it with the
screw.
3. Insert the 6 AA batteries (not included), with polarity (+/-)
as shown inside the battery compartment .
4. Replace the battery cover.
5. Turn "ON" the Power Switch.
Transmitter
1. Remove the battery cover as shown.
2. Install 2 AA batteries (not included), with polarity (+/-) as
shown inside the battery compartment.
3. Replace the battery cover.
Your transmitter is equipped with a special
automatic ON battery-saving feature. Just turn your
vehicle ON. Then push either transmitter control to
run and control your vehicle.
9.6V d.c. NiMH,
It is recommended that you use at minimum
a 700mAh rechargeable battery for best
performance.
6XAA
9,6V
Advertisement
