Download Print this page

Driving Tips; Battery Installation - Mattel Tyco R/C Batman RADIO CONTROL BATCYCLE Manual

Advertisement

III. DRIVING TIPS
1. To start driving, gently hand-launch your vehicle. Set
it on the ground and give it a small push while press-
ing down on the left button to go forward.
Ä
Be sure to hold the vehicle by the driver figure, keep-
ing your fingers clear of the wheels.
2. You can also start with your vehicle resting on its
side skid plate: push the left button forward and steer
with the right button (into and then out of the turn).
Your vehicle will get up and go!
3. Your vehicle is designed to run on smooth, hard
surfaces only.
4. When you want to stop, it's best to turn into a skid
while braking, instead of hitting the brakes suddenly
while going straight.
IV. BATTERY INSTALLATION
q TRANSMITTER
1. Slide the battery door open.
2. Install two AA batteries with polarity (-/+) as
shown inside the battery compartment.
3. Replace the battery door.
w VEHICLE
1. Turn your vehicle over. Rotate the battery latch
to release the battery holder.
2. Slide the battery holder toward the latch.
3. Lift the battery holder out of the vehicle.
4. Insert 4 AA batteries into the battery holder,
with polarity (+/-) as shown on the battery
holder.
5. Replace the battery holder in the vehicle and
rotate the latch until it clicks shut, locking the
battery holder in place.
4.
5.
q
w
1.
3.
2x AA
2.

Advertisement

loading

This manual is also suitable for:

M6337