Pride Jazzy Select Elite with GC2 Technical Troubleshooting Manual page 15

FLASH CODE
The batteries need charging.
1 Flash
There is a bad connection to the batteries.
There is a bad connection between the left motor
2 Flashes
and the power module.
There is a bad connection between the left motor
3 Flashes
and the brake.
There is a bad connection between the right motor
4 Flashes
and the power module.
There is a bad connection between the right motor
5 Flashes
and the brake.
Left-to-Right
The charge inhibit has been activated.
Ripple of LEDs
7 Flashes
There is a joystick fault.
8 Flashes
There is a control system fault.
9 Flashes
The park brakes have a bad connection.
An excessive voltage has been applied to the control
10 Flashes
system.
Table 1. Jazzy Select Elite Flash Codes
PROBABLE CAUSE(S) POSSIBLE SOLUTION
Check the battery connections. If the battery connections are good, then try charging
the batteries. See "Flash Code #1 - Low Battery Voltage."
Check the left motor connections and wiring harnesses. See "Flash Code #2 - Left
Motor Disconnected."
See "Flash Code #3 - Left Motor Wiring Fault."
Check the right motor connections and wiring harnesses. See "Flash Code #4 -Right
Motor Disconnected."
See "Flash Code #5 - Right Motor Wiring Fault."
Make sure that the battery charger is not connected to the power base. See "Section
2 - Battery Condition Meter Scrolls - Inhibit Active."
Make sure the joystick is in the center position and then power off and on again. See
"Flash Code #7 - Possible Joystick Fault."
Check power module and joystick module connections and wiring. See "Flash Code
#8 - Possible Controller Fault."
Check the left and right motor connections and wiring. See "Flash Code #9 - Solenoid
Brake Fault."
Check the battery connections. See "Flash Code #10 - High Battery Voltage."