Special Functions - Roland Kiwi Technics JX-3P Manual

3P Upgrade Special Functions
Setting Incoming Midi
Channel
Setting Outgoing Midi
Channel
Setting Sequencer
Outgoing Midi Channel
Factory Restore 1
Factory Restore 2
Program Update
www.kiwitechnics.com
The incoming midi channel can be set to any channel from 0-16. 0=Omni 1-
16=channel number
This is set using the Global Parameter Edit B-1
The outgoing midi channel can be set to any channel from 1-16.
This is set using the Global Parameter Edit B-2
The Sequencer outgoing midi channel can be set to any channel from 1-16.
This is set using the Global Parameter Edit B-3
Programs 1-32 can be restored to factory original by the following actions
1) Press 'Tape Memory'. The Tape Memory Light will begin to flash
2) Press 'Bank D' button. The 'D' light will start to flash
3) Press 'Tone 16' button. The Tone 16 and Edit Write buttons will begin to fast
flash.
4) Press Edit Write to start restore or Tape Memory to cancel
Only Programs 1-32 (Banks A & B) are overwritten and
set to off. To Cancel press Tape Memory before Write is pressed
The 3P will stop responding for a short period while the restore is being done.
Programs 1-256 can be restored to factory settings by the following action
Press and hold Edit Write and Seq Write while powering the 3P on.
WARNING - There will be no confirmation and
all Tones, Sequences & Patterns will be cleared.
The Memory Protect must be set to
restore is being done.
The KiwiTechnics 3P Upgrade has built in ability to update the firmware should
updates become available. This section is entered by pressing the Tape button
while the 3P is powered on. The Update file is then 'played' into the 3P using
midiOX or similar. The update progress is displayed on the Tone Lights. Once
complete the Bank D button will light and the 3P should be repowered.
WARNING -
If this procedure fails the 3P will be rendered
unusable and will require a replacement CPU from
KiwiTechnics. Use at your own risk.
The current releases are displayed on the Tone Selector lights for about 1 sec at
power on. Tone 1 - 6 display the program release and 7 - 8 display the Bootloader
release. e.g. Tone 2, 3 & 7 would mean Prog v2.3 and BL v 1
Memory Protect must be
off. The 3P will stop responding while the
3P Upgrade User Manual v400
31