Sequencer - Roland Kiwi Technics JX-3P Manual

Sequencer

www.kiwitechnics.com
The JX-3P Upgrade
polyphonic sequencer that has the
capacity of 124 step automatic
playing. Up to 6 notes can be played
at a time so writing a chord is
possible.
Sequencer Write Button
Press this button, followed by the
sequence number using the tone
buttons (1-16), to write data into the
built in sequencer.
Sequencer Tie Button
In sequencer edit mode this button
will join notes by repeating the last
step.
In Play mode the Tie button will
enable one of 16 saved sequences
to be loaded. Press Tie followed by
Tone number 1-16. The currently
loaded Seq will flash. The loaded
sequence will begin to play after the
current one has reached the last
position if currently playing.
Sequencer Rest Button
In sequencer mode this button will
write rests (no sound) into the
sequence.
contains a Note - if more than 6 notes are used in
one step only the last 6 notes will play.
Rate Knob
This controls
Sequencer clock if the clock source is
selected as internal using parameter
control A-13. If the clock source is from
any other source this control will have
no effect. Also if a clock source is
plugged into the external socket in the
rear of the 3P this will override the
internal clock and this control.
If the 3P has been configured to send
midi Clocks then the Rate control will
set the speed of these.
anything is plugged into the External
Input the internal Clock will
a hardware function of the 3P .
This is to start or stop the sequencer
playing. Each time you press this
button the sequencer will start or stop.
Note - If the clock source is midi,
pattern or external the sequence will not
begin playing until the first clock is
received.
3P Upgrade User Manual v400
the speed
Note - if
stop. This is
Start/Stop Button
15
of the