Roland Kiwi Technics JX-3P Manual page 49

Table 1.0 Command ID
`
$03 (3) Request Tone Edit Buffer Dump
$04 (4) Transmit/Receive Tone Edit
Buffer Dump
Null x 2 + 128 data bytes
www.kiwitechnics.com
Data Byte
$0e (14) = Local Enable
$0f (15) = Enable MidiCC
$10 (16) = Enable Sysex
$11 (17) = Enable Program
Change
$12 (18) = Midi Soft Through
$13 (19) = Soft Through Filter
$14 (20) = Enable Midi Clock
Gen
$15 (21) = Enable Clock Display 0000000x
$16 (22) = Master Slave Control 000000yx
$17 (23) = Fine Tune Offset
$18-$2f (24-47) = Nulls
No Data
2 x Null + 128 bytes data
$00-$13 (0-19) = Tone Name
$14 (20) = DCO1 Wave/Range
$15 (21) = DCO1 Tune
$16 (22) = DCO1 Env Mod Amount
Data Type Data Details
Byte details
7 ------- 0
0000000x x = Off/On (set=On)
0000000x x = Off/On (set=On)
0000000x x = Off/On (set=On)
0000000x x = Off/On (set=On)
0000000x x = Off/On (set=Pass Midi)
Note - Midi real time (>$F8) will always pass
Note - SysEx intended for the 3P will not be passed
000000xx xx = 0 Off - No Filter applied - all midi will pass
xx = 1 All Midi with 3P Midi Channel is not passed
xx = 2 All CC with 3P Midi Channel is not passed
Note - Bank, Panic & MW will still pass with option 2
0000000x x = Off/On (set=Generate Clock)
x = Off/On (set=On)
x = Enable (set=Enabled)
y = Master/slave select (set=Master)
0xxxxxxx (0-127) ~+-10 cents (split control centered at $3f)
Not currently Used
2 x null bytes sent followed by 128 bytes of data in the
following format
Ascii Bytes Tone Name
0000yyxx xx = DCO 1 Range
00=16'
01=8'
10=4'
yy = DCO 1 Wave
00=Saw
01=Pulse
10=Sqr
0xxxxxxx (0-127) Split Control +-63 (+- 1 octave or +-1200 cents)
0xxxxxxx (0-127) Split Control +-63
49
3P Upgrade User Manual v400