Inventory - Grizzly G0457 Owner's Manual

Inventory

The following is a description of the main compo-
nents shipped with your machine. Lay the compo-
nents out to inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
contents (figures 4–5)
A. Bandsaw Unit ............................................. 1
B. Cabinet Stand ............................................. 1
c. Feet ⁄ -16 (Stand) ...................................... 4
3
8
D. Motor .......................................................... 1
E. Blade tension Knob ................................... 1
f. lever handle (Quick release) ................... 1
G. table ........................................................... 1
h. trunnion hand Knobs M10-1.5 (table) ....... 2
I.
Miter gauge ................................................ 1
J.
Fence Assembly ......................................... 1
K. resaw Fence ............................................. 1
L. Front rail .................................................... 1
M. rear rail .................................................... 1
N. Moving plate (Fence).................................. 1
O. lever handle w/nut (Fence) ....................... 1
p. locking Adjustment handle (Fence) .......... 1
hardware (Not shown)
• Cap Screws M8-1.25 x 25 (Motor) .............. 2
• lock Washers 8mm (Motor) ....................... 2
• Fender Washers 8mm (Motor) ................... 2
• Flat Washers 6mm (Front rail) .................. 2
• lock Washers 6mm (Front rail) ................. 2
• hex Bolts M6-1 x 20 (Front rail) ................ 2
• Cap Screws M6-1 x 16 (rear rail) ............. 2
• Flat Washer 8mm (Fence) .......................... 1
• Flange Screw (Blade tension Knob) .......... 1
• hex Bolt M8-1.25 x 80 (positive Stop) ........ 1
• hex nut M8-1.25 (positive Stop) ................ 1
• Carriage Bolts M8-1.25 x 20 (Stand) .......... 6
• Flange nuts M8-1.25 (Stand) ..................... 6
• hex nut M8-1.25 (Quick release) .............. 1
• hex nuts ⁄ -16 (Feet) ................................. 4
3
8
• Flat Washers 10mm (Feet) ......................... 4
• hex Wrench 6mm ....................................... 1
-14-
A
F
e
Qty
figure 4. Bandsaw, stand, motor, and
i
figure 5. table, miter gauge, and hardware
p
o
n
figure 6. Main fence components.
g0457 14" industrial Bandsaw (Mfg. Since 5/11)
B
d
C
components
g
h
bags.
J
M
K
l