Collectors; Support Brackets - Grizzly G1030 Instruction Manual

Collectors

The left and right collectors attach to each side of
the outlet flange and are later supported by the
support bracket assembly. The inside of the col-
lectors are funnel shaped and force the air
around in a cyclone motion. Make sure that the
inside taper (funnel) is facing downward and that
the collector inlet flange faces toward the collec-
tor body. Insert one of the rubber gaskets
between the outlet flange and the collector
flange. Secure with eight (8)
provided. Repeat the procedure for the other col-
lector on the opposite side. Figure 5.
Figure 5. Attaching collector to outlet flange
-12-
5 ⁄ "-18 x 1 ⁄ " bolts
16 2

Support Brackets

There are two lower collector support brackets
which mount to the base, then to the side of the
collectors. There are also two upper bag support
brackets which mount to the collector side which
support the upper bag. Attach the two lower col-
lector brackets to the top edge of the base plate
5
using four (4) ⁄ "-18 x
16
6.
Figure 6. Mounting brackets to base.
Now line up the two holes of the upper support
bracket with the holes on the lower bracket and
the collector. Secure the upper and lower support
brackets to the collector with two (2)
bolts provided. Repeat this procedure for the
brackets on the opposite side. Figure 7.
Figure 7. Mounting collector to brackets.
1
⁄ " bolts provided. Figure
2
5 ⁄ "-18 x
16
G1030 Dust Collector
3 ⁄ "
4