Utility; Part Settings - Roland JX-08 Owner's Manual

5

UTILITY

CONFIGURING THE SETTINGS OF THIS UNIT
This shows you how to configure the settings that apply
to the entire unit, such as part settings, system settings
and so on.
If the SEQ button is lit, press the SEQ button to turn it
off.
1. Press the MENU button.
The MENU button lights up.
2. Use the VALUE knob to select the item, and press
the VALUE knob.
The parameter setting screen appears.
3. Turn the VALUE knob to set the value, and press the
VALUE knob, or press the step button [1] - [5].
4. To exit the settings, press the MENU button.
PArt
[1]
Configures the settings for the
selected part.
[2] KEY
Configures the keyboard settings.
NiDi
[3]
Configures the MIDI-related settings.
SYS
[4]
Configures the system settings.
UTiL
[5]
Select this to use the utilities.

PART SETTINGS

These parameters configure the overall settings for the
parts.
[1] UoL 0–127
Adjusts the part volume.
[2] PAn L 64–r 63
Sets the pan position for each part.
F.typ
[3] 1, 2, 3
Sets the change characteristics, modeled after
an analog synthesizer LPF.
[4] Cndi 0–100
Adds a deteriorated effect to the sound.
[5] EHP OFF, On
When this is on, the amount of change made
by the LFO RATE, VCO CUTOFF FREQ, VCF
RES and VCF ENV is expanded (increased)
beyond that of the original model.
P.UEL
[6] 0–3
Adjusts how much the effect changes the pitch
envelope depending on velocity.
A.UEL
[7] 0–3
Adjusts how much the effect changes the VCA
envelope depending on velocity.
[8] F.UEL 0–3
Adjusts how much the effect changes the VCF
envelope depending on velocity.
[9] N.UEL 0–3
Adjusts how much the effect changes the
MIXER envelope adepending on velocity.
[10] bEnd 2, 3, 4, 7 (semitones)
Sets the variable pitch range for the pitch
bend.
N.Lfo
[11] -63–63
Adjusts the depth of the modulation effect.
[12] P.crU
This sets the curve used by the portamento
effect to change the pitch.
orG
The same curve of change used on
the original model is applied.
LinE
A linear curve of change is applied.
E.1 A non-linear curve (gradual slope) of
change is applied.
E.2
A non-linear curve (steep slope) of
change is applied.
AF.LF
[13] -63–63
Adjusts how much the LFO is changed by
aftertouch.
AF.Fq
[14] -63–63
Adjusts how much the low-pass filter (LPF) is
changed by aftertouch.
[15] AF.LU -63–63
Adjusts how much the tone is changed by
aftertouch.
33