Table of Contents
Advertisement
Water-cooled ice machines – follow steps 8.6 through 8.12.
8.5
TDS switch
• Set the TDS switch on the electrical box:
HIGH: for extended service life
LOW: for low-scale water
8.7
Ice transport tube
➋
• Slide ice machine into docking assembly
ensuring that drain tube is fully seated on
barbed drain fitting
• Insert ice transport tube into coupling and
tighten nut firmly
➋
16
TDS
HIGH
CLEAN
LOW
➊
➊
8.6
Cooling lines
• Install ice machine cooling water lines to
docking assembly
8.8
Water solenoid, shut-off valve,
and potable water line options
If water solenoid is already mounted to
evaporator:
• Insert potable water line into shut-off valve.
If this is an undercounter installation:
• Mount water solenoid atop evaporator and
locate the shut-off valve inside the machine.
Insert potable water line into shut-off valve.
If water solenoid is not mounted and
machine will not be installed under-
counter:
• Mount water solenoid to inside rear (upper
right corner) of docking assembly using one
screw.
• Insert potable water line into shut-off valve -
locate the shut-off valve outside the machine.
•
Insert outgoing line from shut-off valve into
push-in connection of water solenoid.
Cornelius • RIDE Technology
self-contained
In
Out
Advertisement
Table of Contents
