Table of Contents
Advertisement
Connect docking assembly to ice machine.
• Plug must be accessible after final installation.
Air-cooled ice machines – follow steps 8.1 through 8.5.
8.1
Ice transport tube
➋
• Slide ice machine into docking assembly
ensuring that drain tube is fully seated on
barbed drain fitting
• Insert ice transport tube all the way into
coupling and tighten nut firmly
8.3
Power cord
• Remove twist tie
• Carefully pass cord through opening and
plug into wall outlet
• For H_E units, install a suitable plug
Cornelius • RIDE Technology
CAUTION
➊
➊
➋
self-contained
Internal connections
8.2
Water solenoid, shut-off valve,
and potable water line options
If water solenoid is already mounted to
evaporator:
• Insert potable water line into shut-off valve.
If this is an undercounter installation:
• Mount water solenoid atop evaporator and
locate the shut-off valve inside the machine.
Insert potable water line into shut-off valve.
If water solenoid is not mounted and
machine will not be installed under-
counter:
• Mount water solenoid to inside rear (upper
right corner) of docking assembly using one
screw.
• Insert potable water line into shut-off valve -
locate the shut-off valve outside the machine.
•
Insert outgoing line from shut-off valve into
push-in connection of water solenoid.
8.4
Power cord
• Position plate into opening and secure
with supplied screw
8
15
Advertisement
Table of Contents
